Loading up some M1 Garand ammo / Plinking ammo for the 30-06

Was running low on the ammo for my M1 Garand, and my dad needed some 30-06 for his rifle, so I decided to make some. I had previously sized about 1000 brass cases that were waiting to be trimmed, so I started this video with the trimming step and continued. Sorry to all those who wanted to see some brass get lubed and pushed into a resizing die. I need to remember to do a video next time I shoot the ol' Garand. *Side note--with the Garands, you need to make sure you don't hot rod your ammo and bend your op rod. Keep the pressures down to Garand levels.*

Equipment used:

Hornady case lube (not shown)
Hornady reloading dies
Forster Co-ax reloading press
Hornady 150 gr fmj bt bullets
IMR 4064 powder
Hornady powder dispensers
Lyman powder dispenser
Lee factory crimp die
Giraud Power trimmer

Music:

C-Funk - Funkorama by Kevin MacLeod is licensed under a Creative Commons Attribution license (https://creativecommons.org/licenses/by/4.0/)
Source: http://incompetech.com/music/r....oyalty-free/index.ht
Artist: http://incompetech.com/