Homemade Form 1 Silencer Part 4: Threading the Tube

Facing off the ends of some aluminum tube then doing internal threading for both of the end caps!

Remember, this is an item controlled by the 1934 National Firearms act, and requires the approval of a Form 1 with appropriate Tax Stamp before construction may begin!

This project was originally undertaken in November and December of 2015

PATREON http://bit.ly/28X4419
INSTAGRAM http://bit.ly/1NLu9zv
FACEBOOK http://bit.ly/1YDV3d5
TWITTER http://bit.ly/1ToGKYm

Watch the whole homemade .22 silencer series!!

"RetroFuture Clean"
Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0
http://creativecommons.org/licenses/by/3.0/